| Symbol | HV |
|---|---|
| Unit | - |
| Attribute-ID | iso_6336_part_4_hardness_depth_profile_combo |
| Numeric ID | 13301 |
| Value Type | PMString |
The hardness depth profile can be determined according to the following methods:
The Vickers hardness is measured according to ISO 6507 at different tooth depths. The measurement curve HV(y) obtained in this way can be directly specified here. The requirements and specifications of ISO 6336-5 must be observed during measurement. The specified hardness depth profile is used for determining the local material stress at all points along the path of contact (A-E).
Here, the following 4 significant values must be extracted from the empirically determined profile:
| HVsurface | HV on the surface of the tooth flank |
| HVcore | HV in the core of the tooth |
| CHD | Case hardening depth (vertical distance from the tooth flank to the depth at which HV takes on the value 550) |
| yHV,max | Depth y at which the hardness is greatest. If not known, assume yHV,max = 0. |
The values determined here are then used in the equations for method C2.
The calculation method assumes that the hardness profile is smooth and continuous, and that the hardness steadily decreases from the surface to the core.
Note: As the equation used here is an approximation, the value calculated for CHD550 may not be exactly 550HV.
Determination of the hardness depth profile according to Lang using the following significant values:
| HVsurface | HV on the surface of the tooth flank |
| HVcore | HV in the core of the tooth |
| CHD | Case hardening depth (vertical distance from the tooth flank to the depth at which HV takes on the value 550) |
Note: As the equation used here is an approximation, the value calculated for CHD550 may not be exactly 550HV.
Also see: Lang, O. R.: Berechnung und Auslegung induktiv randschichtgehärteter Bauteile, AWT-Tagung „Induktives Randschichthärten“, Darmstadt, 1988
Determination of the hardness depth profile according to Thomas using the following significant values:
| HVsurface | HV on the surface of the tooth flank |
| HVcore | HV in the core of the tooth |
| CHD | Case hardening depth (vertical distance from the tooth flank to the depth at which HV takes on the value 550) |
| yHV,max | Depth y at which the hardness is greatest. If not known, assume yHV,max = 0. |
Note: As the equation used here is an approximation, the value calculated for CHD550 may not be exactly 550HV.
Also see: Thomas, J.: Flankentragfähigkeit und Laufverhalten von Hart-feinbearbeiteten Kegelrädern, doctoral thesis, TU Munich 1998
A method A for determining HV(y) is not specified in the current version of ISO 6336-4.
Source: ISO 6336-4, Section 7.3