Running-in finished/copper plated

Symbol -
Unit -
Attribute-ID iso_6336_20_21_run_in
Numeric ID 19585
Value Type PMString

The selection of whether the running-in is finished or the flanks are copper plated is included in the calculation of the run-in factor XE (ISO6336-21:2022 clause 6.1.8 formula 9).

These scuffing calculation methods presume that the gears are well run-in. In practice, scuffing failure occurs very often during the first few hours in service, e.g. in a full load test run, the acceptance run of vessels or when a new set of gears is built into a production machinery when the gears are run under full load conditions before a proper run-in. 

Investigations show a 1/4 to 1/3 load carrying capacity of a newly manufactured gear flank compared to a properly run-in flank. This should be taken into account by a run-in factor XE.