There are two options for manual specification of the bevel gear geometry:
- Specification in accordance with ISO 23509:
- Initial data for pitch cone parameters: Calculation method, hypoid offset, shaft angle, number of teeth, mean spiral angle of wheel or pinion, outer or mean pitch diameter of wheel, wheel facewidth, cutter radius, number of blade groups
- Initial data for tooth profile parameters: Nominal design pressure angle, influence factor of limit pressure angle, tooth height form (addendum and dedendum angle of wheel), and backlash
- Further initial data for the tooth profile according to data type I (according to European standards) or II (according to AGMA)
- Conventional specification of geometry data:
- Specification of the main geometry: Hypoid offset, shaft angle, normal or face module, normal pressure angle, number of teeth, mean spiral angle of wheel and pinion, facewidth
- Specification of the tooth form data (Specification of reference profile data or of implemented gearing data)
- Specification of the tool data: Cutter module, cutter radius, number of blade groups, profile crowning, cutter edge radii and protuberance