| Symbol | μ |
|---|---|
| Unit | - |
| Attribute-ID | friction_coefficient_asperity_contact |
| Numeric ID | 201333 |
| Value Type | PMDouble |
As the speed decreases, the minimum lubricant film height at the transition speed falls below the critical lubricant film height, which depends on the topography of the surfaces of the bearing and shaft. Below this limit, the rotating surfaces are no longer completely separated by the lubricant and individual roughness peaks come into contact, so that additional solid friction occurs.
Additionally, this interaction leads to an asperity contact pressure that exists simultaneously with the hydrodynamic pressure and provides an additional component to compensate for the bearing load.
The solid contact ratio is calculated according to specified roughness parameters using the Greenwood, Williamson, and Tripp statistical model. The Greenwood and Williamson contact model determines the average contact pressure between a rough and a smooth surface, based on the probability of deformation of an asperite. The deformation of the asperite is determined based on the Hertzian theory. In COMBROS R, the power approach according to Hu et al. is used to approximate the solid contact pressure as a function of the local gap height. The critical gap height is thus:
hkrit = S Rq = S (Rq,12 + Rq,22 )0.5
The factor S indirectly indicates the multiple of h/R at which there is a complete separation of the contact partners; it is usually selected as S=4.