| Symbol | KHβ |
|---|---|
| Unit | - |
| Attribute-ID | face load factor hbeta |
| Numeric ID | 1010 |
| Value Type | PMDouble |
The face load factor describes the effect of the increase of the local load on the flank pressure due to uneven load distribution over the face width.
KHβ can be determined several different ways:
The force distribution can be determined by measuring the root stress on the gear, on the loaded gear unit at operating temperature, or by critical analysis (for example, using the pinion modification in the FVA-Workbench).
Uses the face load factor KHβ determined based on DIN 3990:1987 Part 1 Annex E. First, the shaft-bearing system is solved, and the resulting value for KHβ is used for the calculation of the load carrying capacity.
Uses a load increase value determined from the FE calculation of the maximum pressure in the field of action. The use of this value does not correspond to the method described in DIN 3990:1987 Part 1 Annex E, and is therefore for informational purposes only.
The originally effective tooth trace deviation FβX, for example from measurements, can be specified here.
If the pinion is symmetrically arranged (s/l = 0) and the pinion-shaft diameter corresponds approximately to the root diameter, KHβ can be directly calculated with reasonable approximation. The conditions for use in DIN 3990:1987 Part 1 Chapter 6.1.3 a) must be met.
The portions of the tooth trace deviation caused by deformation of the pinion and manufacturing deviation are taken into account.
If the pinion is symmetrically arranged (s/l = 0) and the pinion-shaft diameter corresponds approximately to the root diameter, KHβ can be directly calculated with reasonable approximation. The conditions for use in DIN 3990:1987 Part 1 Chapter 6.1.3 b) must be met.
The portions of the tooth trace deviation caused by deformation of the pinion and manufacturing deviation are taken into account.
For certain applications, a simplified determination of the face load factor is possible for common gear qualities. Method D is derived from Method C2 for the special case of central mounting of the pinion between the bearings. It is suitable for gear unit designs with rigid shafts as well as for initial rough calculations. The results exhibit a margin of safety of about 10% compared to Method C2.
The requirements and simplifications for using Methods C and D are described in DIN 3990:1987 Part 1.