There are different possibilities of geometry specification for the FE-based tooth contact analysis:
- Gear contour from tools
The tooth contour generated in the geometry calculation is used for the FE tooth contact analysis. You can influence this via the parameters in the Main Geometry tab and the tools used.
- Measured tooth contour
Enables measured gap or tooth contours in GDE format to be taken into account for FE tooth contact analysis. In addition, the specification of a suitable nominal geometry via the parameters in the Main Geometry tab and the tools is required.
- STIRAK contour file
Enables the specification of a gap or tooth contour in the STIRAK contour format to be considered for the FE tooth contact analysis. In addition, the specification of a suitable nominal geometry via the parameters in the Main Geometry tab and the tools is required.