Load sharing factor

Symbol Kγ
Unit -
Attribute-ID force distribution factor
Numeric ID 1036
Value Type PMDouble

In planetary stages, the distribution of the torque to be transmitted can vary for the different planetary meshes. This can be considered in the FVA-Workbench as follows:

Calculation of the torque distribution in the overall system
Here, the load distribution to the planets is determined based on the gearbox stiffnesses, specified offsets of the planetary pins, and any transverse forces acting in the planetary stage. In this case, the load sharing factor Kγ cannot be manually specified. The load capacity is then determined using the combination of the highest calculated torque and the worst face load factor KHß from all engagements. This results in the same safety for all planetary meshes. The "consider resulting torques from the system calculation instead of nominal torques" switch is used to specify whether the torque distribution should be calculated.

Specification of the load sharing factor
If the system calculation is configured such that the nominal torques are used, the load sharing factor Kγ can be manually specified. In this case, the nominal torques in the planetary meshes are multiplied by this factor for the load capacity calculations.