| Symbol | - |
|---|---|
| Unit | - |
| Attribute-ID | gear_mesh_depth_resolution |
| Numeric ID | 19043 |
| Value Type | PMInteger |
Five levels are predefined for the meshing accuracy of the toothing: coarse, medium, fine, very fine, and super fine. The parameters for describing the meshing accuracy and their preset values are described below. Manual specification or modifications to specific parameters should only be made if absolutely necessary. (As the meshing greatly depends on the local geometry, the meshing parameters described below are guide values only, and may not always be strictly adhered to.)
| 1 | Flank resolution in the direction of the tooth height |
| 2 | Flank resolution in the direction of the tooth width |
| 3 | Tooth root resolution in the direction of the profile |
| 4 | Resolution in the direction of the tooth depth |
For a calculation with BEM influence coefficient with FEM wheel body, the mesh accuracy coarse is sufficient in most cases. When using FEM influence coefficient, at least the medium mesh accuracy is recommended. In any case, a convergence analysis by continuously increasing the mesh accuracy is recommended!
| Meshing accuracy of the toothing | Coarse | Medium | Fine | Very fine | Super fine |
| Flank resolution in tooth height direction | 10 | 15 | 20 | 25 | 30 |
| Flank resolution in tooth width direction | 10 | 15 | 20 | 25 | 30 |
| Tooth root resolution in profile direction | 10 | 15 | 20 | 25 | 30 |
| Resolution in tooth depth direction | 5 | 6 | 7 | 8 | 9 |
Note: The calculation time increases exponentially with increasing meshing accuracy of the toothing.