Consider nominal torques for calculations

By default, the actual torques are used for the load capacity calculations and the local procedures. These result from the load distribution (for power split and merging) and by taking loss torques into account (for activated power loss calculation),

If the switch "Consider nominal torques for calculations" is activated, the nominal torques (with equal load sharing and without consideration of losses) are used for the load capacity calculations and the local methods. In this case, the calculation of the component deformations is still based on the torques actually determined in the system calculation.

If the load sharing is determined in the system calculation, a load sharing factor cannot be manually specified for the gear stages.  In this case, calculation according to IEC 61400 Part 4 is also deactivated, as the load sharing factor is determined internally.